How to Calibrate Control Board W10803586 (and Compatible Boards)
Many control boards across Whirlpool, Maytag, Amana, and other brands may appear different — but they are actually built on the same platform and can be calibrated to work properly.
The W10803586 control board (shown in our instructional video) can also replace multiple other part numbers as long as the board powers on. If the board receives power, it can usually be programmed and calibrated to function correctly.
🔧 Condition of These Boards
Condition: New
The boards are either:
- Never used, or
- Pulled from brand-new machines that were never placed into service.
Sometimes the original factory performs a power-on self-test at installation. Our team may also perform a power-on self-test (POST) to confirm full functionality prior to sale. This does not mean the board was used — it means it was technically validated.
⚙️ When Calibration Is Needed
Calibration is important if:
- The board powers on but functions incorrectly
- Certain features are missing
- Compatibility warnings appear from websites or service manuals
Once calibrated, the board should operate normally, as long as there’s no physical or electronic damage.
🔄 Calibration Overview (General Process)
(Exact sequence may vary depending on model — see video for reference)
- Power On the Unit
- Wait 30 seconds
- If LEDs blink or screen activates → calibration is possible
- Enter Calibration Mode
Example:- Press POWER once
- Within 5 seconds, press START three times
- Lights should flash — calibration mode activated
- Configure Settings
Adjust according to machine specifications:- Unit type (washer/dryer)
- Load size / cycle options
- Motor & spin settings
- Drain pump behavior
- Sensor mapping
- Save Settings
- Press & hold START for 5 seconds
- System should beep or flash to confirm
- Run Diagnostic Test Cycle
- Check motor, water valves, drain pump, heating, sensors
- If anything isn’t correct → repeat calibration
📦 Compatible Part Numbers
All of the following boards can typically be calibrated to work — even if some websites claim they are not compatible:
W10720802 F
W10779753
W10779756
W10779761
W10803585
W10803586
W10841364
W10857313
W10865064
W10915785
W10916478
W11101100
W11101101
W11116590
W11130854
W11159770
W11162436
W11170319
W11211482
W11256105
W11386637
W11476586
W11498796
W11578827
W11608056
W11728862
🧠 Important Reminder
If the board powers on, it should be programmable — even if websites say it isn’t compatible.
The only situation where calibration will not work is when the board is completely dead with no signs of life.
📩 Need Help or Programming Support?
We offer assistance in:
- Calibration
- Compatibility checks
- Identifying board variations
- Technician support & documentation
Contact us if you need help programming or verifying a board.